Code Corporation CR3500 Manual de usuario descargar pdf (Pagina 9)

C004387_07_CR3500_ User_Manual - 3

Save Settings

1.3 - Baery Installaon

Aaching and Detaching the Lithium Ion Baery

The CR3500 can be purchased with a 1950 mAH Lithium Ion baery. To install baery, make sure the baery is in the correct posion

(Figure 1.1). Place the plasc tab of the baery into the reader slot (Figure 1.2). Push the baery in and slide the locking mechanism

down (Figure 1.3).

Note: Baeries ships with approximately 50% baery life. Fully charge baery before use. Approximate charge me is 4 hours when

baery depleted.

Charging Opons: A CR3500 can be charged, via cable, when connected to a host device. Addionally, Code has a full line of charging

opons, please refer to Code’s website at www.codecorp.com. Note: The RS232 interface power adapter must be plugged into a wall

socket for the reader to charge.

Figure 1.1

Figure 1.2

Figure 1.3

1.4 - Aaching Handles

Figure 1.6

1. To aach a Baery Handle, insert the tab on the back of the Baery Handle into the reader’s recessed slot. (Figure 1.4)

2. Press the reader down, towards the handle to snap into place. (Figure 1.5) Oponally, the reader can be further secured

to the handle with two threaded screws on the underside of the reader and handle (screws are included with Baery

Handles). (Figure 6)

3. To detach a Baery Handle, slide the locking mechanism on the reader up and pull the baery handle up and away from

the slot on the reader.

Figure 1.4

1.5 - Powering On/O Reader

To power on the reader, press and hold either of the red trigger buons for one

second (Figure 1.7).

The reader will power down aer 2 hours of non-use. To change the default

sengs, please see Secon 4.6 - Reader Power O Sengs.

Figure 1.5

Figure 1.7

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Sin comentarios

Code Corporation CR3500 Manual de usuario Pagina 9