Code Corporation CR3500 Manual de usuario descargar pdf (Pagina 22)

C004387_07_CR3500_User_Manual - 16

Save Settings

1.9 - Bluetooth Radio Operaon (Connued)

Permanently Establishing a Connecon

Scan the Save Sengs Code at the boom of the page to make the RF sengs (including which device to connect to) permanent on

the reader:

Disconnecng from the Device

You may force disconnecon by reading the disconnect code below (The CR3500 may not appear

disconnected in the slave Bluetooth connecon manager for 10 – 15 seconds aer the command is issued). The CR3500 will also

disconnect aer 90 seconds of inacvity (Note: You may change the radio sleep me out seng; however, it may reduce baery life).

Bluetooth Disconnect

Reconnecng to the Device

If the device is saved in RF mode and has a save connecon (save was performed while connected) it will automacally reconnect

when:

1. CR3500 is powered up

2. CR3500 wakes from sleep mode

3. CR3500 reads another code

1.9.2 - Bluetooth Radio Auto Connect

Auto Connect: Aer coming out of sleep mode or aer powering up the CR3500 tries to auto connect with the last Bluetooth radio

with which it was connected if the steps (previous) were followed (see Secon 1.9.1 - Connecng with a Quick Connect Code). You may

also re-connect by scanning a QuickConnect code.

Scan the following codes to enable or disable Auto Connect feature for the Bluetooth radio:

Bluetooth Radio Bluetooth Radio

Auto Connect: On (Default) Auto Connect: O

1.9.3 - Bluetooth Radio Auto Disconnect

Auto Disconnect: This feature is used when mulple CR3500 readers are connecng to the same Bluetooth Radio. By enabling Auto

Disconnect the CR3500 radio disconnects aer each data transmission, allowing other radios to connect.

Scan the following codes to enable or disable Auto Disconnect feature for the Bluetooth radio:

Bluetooth Radio Bluetooth Radio

Auto Disconnect: On Auto Disconnect: O (Default)

Note: Auto Connect should always be

set to “On” if Auto Disconnect is set

to “On”. Otherwise the QuickConnect

code would need to be re-scanned

aer every disconnect.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Sin comentarios

Code Corporation CR3500 Manual de usuario Pagina 22