Code Corporation CR3500 Manual de usuario descargar pdf (Pagina 14)

C004387_07_CR3500_User_Manual - 8

Save Settings

CR3500 with Cabled Handle - If a handle was purchased for use with the CR3500, the 8-pin DIN connector is at the boom of the

handle (Figure 1.11). Insert the 8-pin connector and rmly push the cable into the handle. The cable has a locking mechanism that will

rmly hold the cable in place. If using the H2 cabled handle, for addional stability, there is an oponal cable aachement clip that can

secure the cable to the handle with two threaded screws (Figure 1.12).

1.8 - Cabled Operaon

1.8.1- Introducon

The CR3500 is a Mul-Interface Unit (MIU) and is available with USB and RS232 cables. All of the cables are connected to the CR3500

with a 8-pin DIN connector (Figure 1.8).

Hand Held CR3500 - To install a cable directly to the CR3500, correctly line up the 8-pin DIN connector into the back end of the reader.

The arrows on the connector should be facing down (Figure 1.9). When the reader and the cable connector are lined up, rmly push

the cable into the reader. The cable has a locking mechanism that will rmly hold the cable in place (Figure 1.10). To deach the cable

from the reader, you must pinch the plasc on the 8-pin DIN and pull back to disengage the connector.

Figure 1.9 Figure 1.10

Figure 1.11

Figure 1.12

Figure 1.8

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Sin comentarios

Code Corporation CR3500 Manual de usuario Pagina 14