Code Corporation Code Reader 2.0 Manual de usuario descargar pdf (Pagina 42)

C001537_18_CR2_User_Manual 36

Save Settings

2.11.1 - Continuous Scan - Sleep Time Out

Scan one of the codes below to set the amount of time a cabled CR2 will operate in continuous scan mode, without a

decode, before entering sleep mode:

Cabled - 2 hours (Default) Cabled - Always

Scan one of the codes below to set the amount of time an uncabled CR2 will operate in continuous scan mode before

entering sleep mode:

Uncabled - 5 minutes (Default) Uncabled - 15 Minutes Uncabled - 30 Minutes

Note: This function is only recommended for short term use because of battery consumption.

2.11.2 - Continuous Scan - Trigger Delays

Scan the following codes to set delay time between scans:

0 Seconds (Default) 1 Second 3 Seconds

2.11.3 - Continuous Scan - Duplicate Scan Delay

Scan the following codes to set the delay time for reading duplicate codes:

0 Seconds (Default) 1 Second 3 Seconds

2.11 - Continuous Scan Settings

2.12 - Motion Detection Scan Settings

Scan the following codes to set the reader to read when it detects motion in its scanning zone.

On Off (Default)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 66 67

Sin comentarios

Code Corporation Code Reader 2.0 Manual de usuario Pagina 42